engraving machine engraving process limit phenomenon
Check carving path is more than the engraving area; soft limit parameter settings in the software.
◆ engraving machine to send the software does not open, carved things deformity.
Re-install the new systems and software; Check X-, Y-axis screw and screw is loose; chisel has a problem.
◆ the process of engraving machine spindle motor suddenly stall or turn slow
An operating voltage instability or overload, add a regulator can; 2 Check the middle line is connected, thread whether there is a sealing off.
◆ engraving machine set origin, sometimes forward, right offset distance uncertain
A limit switch failure, in the process of the system back to the origin of the limit switch has been closed and bounce for the limit switch can be; 2. Drive line loose, try to fixed tight to.
◆ engraving machine starts reset X axis, Y axis, Z-axis location uncertain
One. Bad limit switch (limit switch is always closed), the change of the can; 2 bad drive line (X axis, 14-pin and 15 pin short circuit, the Y-axis 13-pin and 15 pin short circuit, Z-axis and 31-pin and 15 pin short-circuit), you can drive line or short circuit punishment open to change; bad driver board to change the driver board.