engraving machine engraving misplaced or wrong size
Check the path of engraving software is correct or not; 2. Check screw gap size and the fastening screws of the rod there are no loose; Check software parameters are set correctly.
◆ the Z-axis engraving machine X-axis walk a certain period of not carrying knives, go up go down
(1) Check the Z-axis stepper motor is running, the size of the power and drive current, or their own fault; 2. Check the Z-axis stepper motor cable is bad or intermittent; control card failure.
◆ engraving machine spindle motor does not turn or reverse
A. Check the inverter parameter settings; inverter signal line is reversed.
◆ engraving machine to open the software boot, appear axis Close
Drive or computer output signal line is poor contact; two motor wire connection is bad.